Eldorado 1992-1995 Custom Mount
Click on a thumbnail to enlarge
Click image to enlarge
Pro Fit International Vehicle Specific Mounts are made specifically to fit each vehicle. They use existing dash fittings so there is no need to alter the interior of your vehicle and they blend in well for a much cleaner and more finished look. The picture above shows where it installs in your car and included below are the installation instructions to give you an idea of how difficult it is to install into your vehicle (also, the pdf manual is available above by clicking on the pdf icon). On some cars the VSM can be easily installed without tools in a few minutes, in some cars it requires more effort.
We highly recommend using the Pro-Fit Easy Swivel in addition to the mount for clearance and tilting.
TOOLS REQUIRED: 1/410mm socket, ratchet and extension, 7mm open end wrench, hook tool,
protective cloth.
PARTS INCLUDED: Pro.Fit VSMTM, instructions.
LOCATION: To the right of the radio.
STEP 1. Begin by removing the small black trim ring that surrounds
the radio. Insert the hook tool behind the upper right corner of the trim
ring and pull toward you to loosen the ring. Once the ring is loose, work
the remaining three (3) corners of the trim ring loose. Set the trim ring
aside. Turn the ignition to the ON position and shift the transmission
into low gear. Just above the ashtray door, grasp the top section of the
bezel that surrounds the transmission shifter and pull toward you to
release two (2) clips. Insert the hook tool behind the right rear corner of
the bezel just behind the shifter. Pull upward to release one (1) clip.
Perform the same action in the left rear corner releasing one (1) more
clip. Grasp the rear of the bezel and continue working loose two (2) clips
on the left and right sides of the shifter. Work the bezel up and over the
shifter knob and disconnect all wiring. Set the bezel aside.
STEP 2. Locate two (2) 10mm nuts just below the radio. Using the
10mm socket, ratchet and extension, remove those two nuts. Set the nuts
aside. Grasp the radio and pull the radio out of its cavity. Let the radio
rest on the a protective cloth on the center console. DO NOT DIS-
CONNECT THE WIRING TO THE RADIO.
STEP 3. Locate two (2) 7mm screws on the right, inside the radio cav-
ity. Remove the lower screw with the 7mm open end wrench. Set that
screw aside. Loosen the top screw just enough to get the slot in the
Pro.Fit mount behind it. Once the mount is in place, insert the bottom
screw and tighten down the mount securing both screws.
STEP 4. Re-assemble the dash in reverse order securing all wiring, nuts
and clips. Install the hang-up cup onto the Pro.Fit VSMTM.
This product contains the following items:
