2.2CL 3.0CL 1997 Custom Mount

Pro Fit International Vehicle Specific Mounts are made specifically to fit each vehicle. They use existing dash fittings so there is no need to alter the interior of your vehicle and they blend in well for a much cleaner and more finished look. The picture above shows where it installs in your car and included below are the installation instructions to give you an idea of how difficult it is to install into your vehicle (also, the pdf manual is available above by clicking on the pdf icon). On some cars the VSM can be easily installed without tools in a few minutes, in some cars it requires more effort.

We highly recommend using the Pro-Fit Easy Swivel in addition to the mount for clearance and tilting.

TOOLS REQUIRED: Hook tool, 8mm socket , ratchet , and extension, #2 Phillips screwdriver, 5/64 drill
bit and drill, marking pen, small coarse file, masking tape.
PARTS INCLUDED: Pro.Fit VSMTM, one #8x3/8 screw and instructions.
LOCATION: To the right of the radio.
STEP 1.
Begin by opening cubby hole door located below the radio. Insert
hook tool in cubby hole at right side of bezel between bezel and
felt liner. Pull toward you to release right clip. Repeat on left side.
Insert hook tool in the upper left corner of radio and pull toward
you releasing one (1) top clip. Grasp the bezel with hands and pull
toward you releasing two (2) bottom clips. Disconnect all wiring
and set bezel aside.
STEP 2.
Locate and remove bolt to the right of the radio using your 8mm
socket, extension and ratchet. Align Pro.Fit VSMTM with bolt hole.
Insert and tighten factory bolt. Using the remaining hole in the
Pro.Fit VSMTM as a guide, drill a pilot hole with your 5/64 drill
bit and drill. Insert provided screw and tighten with #2 Phillips
screwdriver. Put bezel back into place. With marking pen, mark the
area where a rib on the bezel must be filed in order for the bezel
to fit flush. NOTE: This area is where the rib on the bezel meets
the 11TM. Pull the bezel out and cover the area to be filed with
masking tape. NOTE: This is to protect the rest of the bezel
from damage. With a small coarse file, remove about 1/16 of
material off of the marked area of bezel.
STEP 3.
Reconnect all wiring to bezel and put bezel back into place secur-
ing all clips. Attach hang-up cup onto Pro.Fit VSMTM.

COMPATIBILITY, SPECS AND DOCS