Pro Fit International Vehicle Specific Mounts are made specifically to fit each vehicle. They use existing dash fittings so there is no need to alter the interior of your vehicle and they blend in well for a much cleaner and more finished look. The picture above shows where it installs in your car and included below are the installation instructions to give you an idea of how difficult it is to install into your vehicle (also, the pdf manual is available above by clicking on the pdf icon). On some cars the VSM can be easily installed without tools in a few minutes, in some cars it requires more effort.
We highly recommend using the Pro-Fit Easy Swivel in addition to the mount for clearance and tilting.
TOOLS REQUIRED: #2 Phillips screwdriver, flat screwdriver, marking pen, 5/64 drill
bit and drill.
PARTS INCLUDED: Pro.Fit VSMTM, two (2) #10-3/4 screws, instructions.
LOCATION: To the right of the climate control.
STEP 1.
Begin by removing two (2) screws on top of the cup holder
assembly. Slide the unit out and set to the side.
2 Screws
STEP 2.
Place the Pro.Fit VSMTM to the right of the climate control. The
bottom of the mount will rest into a small groove in the dash pad.
(See 2nd picture.) While holding the mount in place, mark two
(2) pilot holes, using the the Pro.Fit VSMTM as a guide. Set the
custom mount aside and carefully drill two (2) 5/64 pilot holes.
STEP 3.
To simplify installation of your custom mount, start both
#10-3/4 screws before setting the custom mount in place.
Tighten the screws halfway and then slide the custom mount into
place. Finish tightening the screws. Reassemble the dash in
Align Mount
reverse order.
Here