Your Shopping Cart

Items
0
Cost
$0.00
LOGIN CHECKOUT

Allroad Quattro AT5 2000-2006 Custom Mount

PART NUMBERS AU-54-00

DISCONTINUED


Au-54-00-1_2
Click image to enlarge

Pro Fit International Vehicle Specific Mounts are made specifically to fit each vehicle. They use existing dash fittings so there is no need to alter the interior of your vehicle and they blend in well for a much cleaner and more finished look. The picture above shows where it installs in your car and included below are the installation instructions to give you an idea of how difficult it is to install into your vehicle (also, the pdf manual is available above by clicking on the pdf icon). On some cars the VSM can be easily installed without tools in a few minutes, in some cars it requires more effort.

We highly recommend using the Pro- Fit Easy Swivel in addition to the mount for clearance and tilting.



TOOLS REQUIRED: Two (2) sets Mercedes/Audi radio removal tools,
smooth, flat bladed screwdriver, 5/16 socket and driver.
PARTS INCLUDED: Pro.Fit VSM®, instructions.
LOCATION: Right of radio.
STEP 1. Begin by removing the radio. CAUTION: Do not
disconnect any wiring to the radio at any time. Insert four (4)
radio removal tools into the removal slots. (See photo #1.) There
is an anti-vibration o-ring located behind the radio trim bezel that
needs to be loosen in order to slide out the radio. With the radio
removal tools in place, insert a smooth, thin, flat bladed screwdriver
in between the radio trim bezel and the dash pad on the right side of
the radio. (See black dots in photo # 1). Wiggling the screwdriver
gently will release the o-ring and radio from the dash. After
completing the same procedure on the left side, slide the radio
forward enough to access the two (2) 5/16 hex bolts on the right
side of the radio cavity. (See photo # 2). Again, do not disconnect
any wiring to the radio.
STEP 2. Remove the two (2) 5/16 hex bolts from the right side of
the radio cavity with a 5/16 socket and driver. (See photo # 2).
Align the Pro.Fit VSM® over the bolt hole, insert the two (2) 5/16
hex bolts and tighten. Reassemble the dash in reverse order.

COMPATIBILITY, SPECS AND DOCS

Icon_pdf AU5400.pdf