Toyota Camry Solara 2003-2008 Custom Mount

Pro Fit International Vehicle Specific Mounts are made specifically to fit each vehicle. They use existing dash fittings so there is no need to alter the interior of your vehicle and they blend in well for a much cleaner and more finished look. The picture above shows where it installs in your car and included below are the installation instructions to give you an idea of how difficult it is to install into your vehicle (also, the pdf manual is available above by clicking on the pdf icon). On some cars the VSM can be easily installed without tools in a few minutes, in some cars it requires more effort.

TOOLS REQUIRED: #2 Phillips screwdriver, drill and 5/64 bit, Dash trim removal tool (DM-40-22), 10mm
nut driver, protective cloth
PARTS INCLUDED: Pro.Fit Legend, instructions, two (2) # 8 x 1/2 screws, mounting tape,
hardware pack, surface prep kit
LOCATION: Right of climate control

STEP 1. Set parking brake and put gear shift into low. Open arm rest.
Remove gear shift bezel by inserting trim tool behind lower right
corner of bezel and prying up. Work tool around bezel until all clips
are released. Lift bezel up over gear shift and set aside. Wiring does
not need to be disconnected.

STEP 2. Use the trim tool to pry out the pocket below the climate
control. Set pocket to the side. Do not disconnect wiring.

STEP 3. Insert the dash tool behind the lower left corner of the air
vent. Photo 1. Pry out approximately 1/8 to slightly release clip.
Slide the trim tool to the right, releasing center and right clip slightly.
Do not try to remove the bottom clips, only pulled out 1/8. Insert
trim tool behind the upper left corner of the vent assembly. Pry
outward to release clip. Work the tool to the right until vent top is
free. Pull top forward and lift bottom clips out of holders and set
vent assembly on dash. Do not disconnect vent wiring.

STEP 4. Remove four (4) 10mm bolts from the four corners of the
radio / climate control module. Slide radio / climate control out of
the cavity, wrap in a protective cloth, and let hang down. DO NOT
disconnect any wiring to the radio module.

STEP 5. Align the bottom of the Legend VSM even with the top of
the clip hole. Photo 2. Using the screw holes as a guide, mark the
location of the top and bottom hole. Carefully drill two (2) pilot
holes at the marked location using a 5/64 drill bit and drill. Align
the LEGEND over the pilot holes, insert two (2) # 8 x 1/2 screws and
tighten.

STEP 6. Re-assemble the dash in reverse order.

COMPATIBILITY, SPECS AND DOCS

CONTAINS THESE PARTS

1 x Pro-Fit MV-50-03-L-P 2004-2006 Custom Mount 19.99