Freightliner Conventional 1989-2004 Custom Mount

Pro Fit International Vehicle Specific Mounts are made specifically to fit each vehicle. They use existing dash fittings so there is no need to alter the interior of your vehicle and they blend in well for a much cleaner and more finished look. The picture above shows where it installs in your car and included below are the installation instructions to give you an idea of how difficult it is to install into your vehicle (also, the pdf manual is available above by clicking on the pdf icon). On some cars the VSM can be easily installed without tools in a few minutes, in some cars it requires more effort.

We highly recommend using the Pro-Fit Easy Swivel in addition to the mount for clearance and tilting.

TOOLS REQUIRED: T-20 Torx screwdriver.
PARTS INCLUDED: Pro.Fit VSMTM mount, instructions, metal spacer.
LOCATION: To the right of the climate control.
STEP 1. Begin by locating and removing two (2) factory
Torx screws to the right of the climate control using the Torx
driver. Set screws aside.
STEP 2. Install phone holder onto Pro.Fit VSMTM. Grasp the
right side of the climate control panel and pull out just
enough to slide the Pro.Fit VSMTM behind it. Place the metal
spacer in behind the panel and in front of the Pro.Fit VSMTM.
Align the holes in the spacer, panel, and Pro.Fit VSMTM.
Insert the two (2) factory Torx screws and tighten.
NOTE: The
metal spacer must be between the Pro.Fit VSMTM and the
back side of the trim panel. This is to provide support for
the panel.

COMPATIBILITY, SPECS AND DOCS

FR-30-89.pdf

WARNING, VIDEO AND FAQ