Easy to install vehicle specific mount from Panavise will give your SIRIUS install a clean and sharp look. All vehicle specific mounts come with instructions, but most require at least some disassembly of the dashboard of your vehicle and about 30-60 minutes time if you are reasonably technical. Installation does not require any special skills, but if you are not comfortable disassembling your dashboard you should consider having a local installer professionally install it for you.
We highly recommend using the Panavise Tipper in addition to the mount for clearance and tilting.
MOUNTING LOCATION: Right side of climate control CR
TOOLS REQUIRED: Pry tool, Phillips head screwdriver, Phillips head bit on ratchet
HARDWARE INCLUDED: None
For the Honda Pilot 2003-2008
STEP #1: Use the pry tool with protective tape to protect dash, to remove the outside bezel to the right side of the climate control. Start by inserting the pry tool at the top of the bezel and pry towards the back of the car. This will release (2) clips. Continue to tilt to the back of the car and lift to release (1) more clip. Set this bezel aside.
STEP #2: Use Phillips head screwdriver to remove the (1) screw to the right of the climate control. Place the InDash by PanaVise over the screw hole and reinstall the screw with the Phillips bit ratchet.. Make sure the InDash by PanaVise is flush up against the right side of the climate control bezel, for optimum fit of the outside bezel.
STEP #3: Replace outside bezel by putting it under the InDash by PanaVise. Then insert the bottom of the bezel and push in the (1) clip. Tilt in the bezel to finish the installation.