Ram Cargo Van 1998-2004 Custom Mount

Pro Fit International Vehicle Specific Mounts are made specifically to fit each vehicle. They use existing dash fittings so there is no need to alter the interior of your vehicle and they blend in well for a much cleaner and more finished look. The picture above shows where it installs in your car and included below are the installation instructions to give you an idea of how difficult it is to install into your vehicle (also, the pdf manual is available above by clicking on the pdf icon). On some cars the VSM can be easily installed without tools in a few minutes, in some cars it requires more effort.



We highly recommend using the Pro-Fit Easy Swivel in addition to the mount for clearance and tilting.

TOOLS REQUIRED: #2 Phillips screwdriver, hook tool, 5/64"drill bit and drill, marking pen.
PARTS INCLUDED: Pro.Fit VSMTM, instructions, three #8x1/2"
LOCATION: To the right of the far right air vent that is integrated into the bezel.
STEP 1.
Begin by removing the bezel that surrounds the radio, climate
control, and instrument cluster. To do this insert the hook tool
behind the lower right corner of the bezel just below the air vent.
Carefully pull toward you to release the first clip. Perform this
same action in the upper right corner of the bezel releasing the top
right clip. Grasp the bezel just above the cigarette lighter.
Carefully pull toward you releasing a series of clips that hold the
top of the bezel and extends over to the driver"s side door.
Continue to work the bottom clips loose all the way over to the
right of the climate control. There are a total of nine clips holding
the bezel in place. Remove the bezel from the dash and set it
aside.
STEP 2.
Inside the air vent cavity on the right side, locate a section of plas-
tic. On this section of plastic there are two pieces of felt. Place the
Pro.Fit VSMTM just above the lower piece of felt. Using the holes
in the mount as a guide, mark three pilot holes with the marking
pen. Set the mount aside. Carefully drill three pilot holes using the
5/64" drill bit and drill. Install the phone holder onto the Pro.Fit
VSMTM . Place the Pro.Fit VSMTM over the three pilot holes.
Insert the provided screws and tighten.
STEP 3.
Re-assemble the dash in reverse order securing all nine clips.

COMPATIBILITY, SPECS AND DOCS