TL (with or w/o GPS) 2002-2003 Custom Mount

Pro Fit International Vehicle Specific Mounts are made specifically to fit each vehicle. They use existing dash fittings so there is no need to alter the interior of your vehicle and they blend in well for a much cleaner and more finished look. The picture above shows where it installs in your car and included below are the installation instructions to give you an idea of how difficult it is to install into your vehicle (also, the pdf manual is available above by clicking on the pdf icon). On some cars the VSM can be easily installed without tools in a few minutes, in some cars it requires more effort.



We highly recommend using the Pro-Fit Easy Swivel in addition to the mount for clearance and tilting.

TOOLS REQUIRED: #1 Phillips screwdriver, hook tool.
PARTS INCLUDED: Pro.Fit VSM®, instructions.
LOCATION: To the right of the radio.
STEP 1.
Open the armrest door. Locate the long simulated wood grain trim
panel that runs along the right side of the center console. Under
the armrest door, insert the hook tool underneath the trim panel
towards the rear. Lift upward to release the first clip. Grasp the
trim panel and carefully pull upward to release the remaining four
clips that run all the way up to the right of the radio. Once the
clips are released, set the trim panel aside.
STEP 2.
Locate the top right screw to the right of the radio just below the
centering pin. Remove the screw with the #1 Phillips screwdriv-
er. Place the Pro.Fit VSM® over this screw hole. Insert the fac-
tory screw and tighten. NOTE: Use the large hole on the face of
the Pro.Fit VSM® to gain easy access to the factory screw for
tightening.
STEP 3.
Carefully re-assemble the trim panel making sure all five (5) clips
are secure. Install the phone holder onto the Pro.Fit VSM®.

COMPATIBILITY, SPECS AND DOCS

AC-54-99.pdf

AC-54-99.pdf

WARNING, VIDEO AND FAQ